Select Columns in a Data Table | JMP 13.2

JMP Support 800.450.0135 (US)

Documentation Feedback
Your feedback is important to us. us any comments about our documentation.

Using JMP • Enter and Edit Data • Select Columns • Select Columns in a Data Table

•

Select Columns in a Data Table

To select one entire column

•

In the data grid, click in the empty space around the column name.

•

In the Columns panel, click the column name.

To select a specific column number

1.

Select Cols > Column Selection > Go to.

2.

Enter the column number or name and click OK.

To select multiple columns

•

For continuous selection:

–

Click and drag the cursor over the column name.

–

Hold down the Shift key and click the first and last columns of the desired range.

–

Hold down the Shift key and press the left or right arrow key.

•

For columns that are not next to each other:

–

Hold down the Ctrl key and click on each column.

To select or deselect all columns

•

Hold down the Shift key and click the upper triangular area in the upper left corner of the data grid to select. Click again in the same area to deselect all columns. See Upper Triangular Area.

Upper Triangular Area

Tip: To clear all highlighted areas in the data table, press the Esc key.

To invert the column selection

Select Cols > Column Selection > Invert Column Selection. Only the previously deselected columns are selected.

•

Help created on 9/19/2017