Red Triangle Menu Options

JMP Support 800.450.0135 (US)

Documentation Feedback
Your feedback is important to us. us any comments about our documentation.

Quality and Process Methods • Control Chart Builder • Control Chart Builder Options • Red Triangle Menu Options

•

Red Triangle Menu Options

Show Control Panel

Shows or hides the following elements:

–

–

the Select Columns box

–

the drop zone borders

Show Limit Summaries

Shows or hides the Limit Summaries report. This report shows the control limits (LCL and UCL), the center line (Avg), the Points and Limits plotted, and the Sample Size for the chart. Sample size is not shown for rare event charts.

Show Capability

(Available only for Shewhart Variables charts that have a column with a Spec Limits column property.) Shows or hides the Process Capability Analysis report. For more information about the Process Capability Analysis report, see The Process Capability Report.

Note: Show Capability is not available if the response variable has no variation.

Retrieves the control limits that are stored in a data table.

Show Excluded Region

Shows or hides the regions of the chart where samples have been excluded.

Set Subgroup Size

Sets a subgroup size. Missing values are taken into account when computing limits and sigma.

Saves the control limits in one of the following ways:

Saves control limits as a column property in the existing data table for the response variable. If the limits are constant, LCL, Avg, and UCL values for each chart type in the report are saved. This option is not available with phase charts. In addition, the option has no effect if the sample sizes are not constant for each chart.

Saves the standard deviation and mean for each chart into a new data table. If the limits are constant, the LCL, Avg, and UCL for each chart are saved as well. If there are phases, a new set of values is saved for each phase.

Creates a new data table containing such information as the sample label, sample sizes, statistic being plotted, center line, control limits, and any tests, warnings and failures. The specific statistics included in the table depend on the type of chart.

Include Missing Categories

Enables the graph to collect rows with missing values in a categorical column, and displays the missing values on the graph as a separate category. If this option is disabled, all rows with a missing X value are removed from the calculations, in addition to being hidden from the graph.

This option is not available for continuous X variables or categorical Y variables because there is no compelling way to display the collected missing values on the relevant axes. By default, this option is enabled.

Note: If Include Missing Categories is enabled, capability analysis results in Control Chart Builder do not match those in the Process Capability platform if a categorical X variable has missing values.

Use Event Chooser

(Applies only for attribute charts with numeric non-continuous Y variables.) Categorizes ordinal numeric data and offers individual numeric-level modeling selections.

See Local Data Filter, Redo Menus, and Save Script Menus in the Using JMP book for more information about the following options:

Local Data Filter

Shows or hides the local data filter that enables you to filter the data used in a specific report.

Contains options that enable you to repeat or relaunch the analysis. In platforms that support the feature, the Automatic Recalc option immediately reflects the changes that you make to the data table in the corresponding report window.

Contains options that enable you to save a script that reproduces the report to several destinations.

Note: Column Switcher is available only for a single Y variable having two or fewer associated charts. Based on the selected chart type, only columns that are appropriate for the Y role are included in the Column Switcher column list.

Note: In Control Chart Builder, the Automatic Recalc option is turned on by default and cannot be turned off.

•

Help created on 10/11/2018