Select Columns

JMP Support 800.450.0135 (US)

Documentation Feedback
Your feedback is important to us. us any comments about our documentation.

Using JMP • Enter and Edit Data • Select Columns

•

There are several ways to select columns:

•

Select columns in the data table itself. See Select Columns in a Data Table.

•

In a data table that has many columns, select columns by attributes, properties, and statistics in the Columns Viewer. See Select Columns in the Columns Viewer.

•

Find the next or previously selected column. See Locate Next and Previously Selected Columns.

Select Columns in a Data Table

To select one entire column

•

In the data grid, click in the empty space around the column name.

•

In the Columns panel, click the column name.

To select a specific column number

1.

Select Cols > Column Selection > Go to.

2.

Enter the column number or name and click OK.

To select multiple columns

•

For continuous selection:

–

Click and drag the cursor over the column name.

–

Hold down the Shift key and click the first and last columns of the desired range.

–

Hold down the Shift key and press the left or right arrow key.

•

For columns that are not next to each other:

–

Hold down the Ctrl key and click on each column.

To select or deselect all columns

•

Hold down the Shift key and click the upper triangular area in the upper left corner of the data grid to select. Click again in the same area to deselect all columns. See Figure 3.9.

Figure 3.9 Upper Triangular Area

Tip: To clear all highlighted areas in the data table, press the Esc key.

To invert the column selection

Select Cols > Column Selection > Invert Column Selection. Selects any column that is currently deselected and deselects any column that is currently selected.

•

Help created on 7/12/2018